AN INTEGRATED ELECTROMAGNETIC MICRO-TURBO-GENERATOR SUPPORTED ON ENCAPSULATED MICROBALL BEARINGS

Loading...
Thumbnail Image

Files

Publication or External Link

Date

Advisor

Ghodssi, Reza

Citation

DRUM DOI

Abstract

This dissertation presents the development of an integrated electromagnetic micro-turbo-generator supported on encapsulated microball bearings for electromechanical power conversion in MEMS (Microelectromechanical Systems) scale. The device is composed of a silicon turbine rotor with magnetic materials that is supported by microballs over a stator with planar, multi-turn, three-phase copper coils. The micro-turbo-generator design exhibits a novel integration of three key technologies and components, namely encapsulated microball bearings, incorporated thick magnetic materials, and wafer-thick stator coils. Encapsulated microball bearings provide a robust supporting mechanism that enables a simple operation and actuation scheme with high mechanical stability. The integration of thick magnetic materials allows for a high magnetic flux density within the stator. The wafer-thick coil design optimizes the flux linkage and decreases the internal impedance of the stator for a higher output power. Geometrical design and device parameters are optimized based on theoretical analysis and finite element simulations. A microfabrication process flow was designed using 15 optical masks and 110 process steps to fabricate the micro-turbo-generators, which demonstrates the complexity in device manufacturing. Two 10 pole devices with 2 and 3 turns per pole were fabricated. Single phase resistances of 46Ω and 220Ω were measured for the two stators, respectively. The device was actuated using pressurized nitrogen flowing through a silicon plumbing layer. A test setup was built to simultaneously measure the gas flow rate, pressure, rotor speed, and output voltage and power. Friction torques in the range of 5.5-33µNm were measured over a speed range of 0-16krpm (kilo rotations per minute) within the microball bearings using spin-down testing methodology. A maximum per-phase sinusoidal open circuit voltage of 0.1V was measured at 23krpm, and a maximum per-phase AC power of 10µW was delivered on a matched load at 10krpm, which are in full-agreement with the estimations based on theoretical analysis and simulations. The micro-turbo-generator presented in this work is capable of converting gas flow into electricity, and can potentially be coupled to a same-scale combustion engine to convert high-density hydrocarbon energy into electrical power to realize a high-density power source for portable electronic systems.

Notes

Rights