Investigation of Enhanced Surface Spray Cooling
| dc.contributor.advisor | Kiger, Ken | en_US |
| dc.contributor.advisor | Kim, Jungho | en_US |
| dc.contributor.author | Silk, Eric A | en_US |
| dc.contributor.department | Mechanical Engineering | en_US |
| dc.contributor.publisher | Digital Repository at the University of Maryland | en_US |
| dc.contributor.publisher | University of Maryland (College Park, Md.) | en_US |
| dc.date.accessioned | 2007-02-01T20:22:57Z | |
| dc.date.available | 2007-02-01T20:22:57Z | |
| dc.date.issued | 2006-11-29 | en_US |
| dc.description.abstract | Phase change technology is a science that is continually finding new applications, from passive refrigeration cycles to semiconductor cooling. The primary heat transfer techniques associated with phase change heat transfer are pool boiling, flow boiling, and spray cooling. Of these techniques, spray cooling is the least studied and the most recent to receive attention in the scientific community. Spray cooling is capable of removing large amounts of heat between the cooled surface and the liquid, with reported heat flux capabilities of up to 1000 W/cm2 for water. Many previous studies have emphasized heat flux as a function of spray parameters and test conditions. Enhanced spray cooling investigations to date have been limited to surface roughness studies. These studies concluded that surface tolerance (i.e. variations in machined surface finish) had an impact upon heat flux when using pressure atomized sprays. Analogous pool boiling studies with enhanced surfaces have shown heat flux enhancement. A spray cooling study using enhanced surfaces beyond the surface roughness range may display heat flux enhancement as well. In the present study, a group of extended and embedded surfaces (straight fins, cubic pin fins, pyramids, dimples and porous tunnels) have been investigated to determine the effects of enhanced surface structure on heat flux. The surface enhancements were machined on the top surface of copper heater blocks with a cross-sectional area of 2.0 cm2. Measurements were also obtained on a flat surface for baseline comparison purposes. Thermal performance data was obtained under saturated (pure fluid at 101 kPa), nominally degassed (chamber pressure of 41.4 kPa) and gassy conditions (chamber with N2 gas at 101 kPa). The study shows that both extended and embedded structures (beyond the surface roughness range) promote heat flux enhancement for both degassed and gassy spray cooling conditions. The study also shows that straight fins provide the best utilization of surface area added for heat transfer. An Energy conservation based CHF correlation for flat surface spray cooling was also developed. CHF predictions were compared against published and non-published studies by several researchers. Results for the correlations performance show an average mean error of ±17.6% with an accuracy of ±30% for 88% of the data set compared against. | en_US |
| dc.format.extent | 1538597 bytes | |
| dc.format.mimetype | application/pdf | |
| dc.identifier.uri | http://hdl.handle.net/1903/4179 | |
| dc.language.iso | en_US | |
| dc.subject.pqcontrolled | Engineering, Mechanical | en_US |
| dc.subject.pqcontrolled | Engineering, Mechanical | en_US |
| dc.subject.pquncontrolled | Spray cooling | en_US |
| dc.subject.pquncontrolled | Heat transfer | en_US |
| dc.subject.pquncontrolled | Enhanced Surfaces | en_US |
| dc.subject.pquncontrolled | CHF correlations | en_US |
| dc.title | Investigation of Enhanced Surface Spray Cooling | en_US |
| dc.type | Dissertation | en_US |
Files
Original bundle
1 - 1 of 1