Kim, ChangsuCure shrinkage accumulated only after the gel point is known as effective cure shrinkage (ECS), which produces residual stresses inside molded components. The ECS of an epoxy-based molding compound (EMC) is measured by an embedded fiber Bragg grating (FBG) sensor. Under a typical molding condition, a high mold pressure inherently produces large friction between EMC and mold inner surfaces, which hinders EMC from contracting freely during curing. A two-stage curing process is developed to cope with the problem. In the first stage, an FBG sensor is embedded in EMC by a molding process, and the FBG-EMC assembly is separated from the mold at room temperature. The molded specimen is heated to a cure temperature rapidly in the second stage using a constraint-free curing fixture. The ECS of an EMC with a filler content of 88 wt% is measured by the proposed method, and its value is 0.077%. The measured ECS can be used to predict the warpage caused by molding processes. The validity of the prediction can be verified only by measuring the warpage during molding. A point-based measurement technique utilizing uniquely-generated multiple beams and binarization-based beam tracing method is developed to cope with the challenges associated with the warpage measurement during molding. The proposed method is implemented successfully to measure the warpage of a bimaterial disk that consists of aluminum and EMC as a function of time during molding process. Measurements are repeated to establish the measurement accuracy of the proposed method.enDissertationMechanical engineering