Show simple item record

dc.contributor.advisorFourney, Williamen_US
dc.contributor.authorMorin, Jasonen_US
dc.date.accessioned2019-06-20T05:38:14Z
dc.date.available2019-06-20T05:38:14Z
dc.date.issued2019en_US
dc.identifierhttps://doi.org/10.13016/2nap-cxjy
dc.identifier.urihttp://hdl.handle.net/1903/22014
dc.description.abstractAdditive manufacturing is becoming an important part of modern manufacturing technology. Before additively manufactured parts gain widespread adoption, the material properties of the additively manufactured material itself must be accurately quantified. Stress strain curves must be produced over a wide variety of test conditions so that accurate modeling of material behavior can be done. Materials that may undergo dynamic loading must therefore be tested under dynamic conditions. In this study the tensile and high strain rate compressive material properties of additively manufactured Inconel 625 are compared to conventionally formed wrought material. The results of testing showed that there is a clear difference in material properties between wrought and additively manufactured Inconel 625 in tension and compression. The additively manufactured tensile samples showed anisotropy between print directions of approximately ±10%. The printed samples had a 35% higher yield strength, a similar ultimate strength, and 20-40% the elongation when compared to wrought. There was also a significant difference in properties between the additive and wrought materials during the compressive tests. The additive material showed little anisotropy and had a 30% higher yield stress than wrought. Additionally, the additive material had a higher strain hardening rate than the wrought samples. No significant strain rate effects were noted.en_US
dc.language.isoenen_US
dc.titleCOMPARISON OF HIGH STRAIN RATE PROPERTIES OF ADDITIVELY MANUFACTURED AND WROUGHT INCONEL 625 VIA KOLSKY BAR TESTINGen_US
dc.typeThesisen_US
dc.contributor.publisherDigital Repository at the University of Marylanden_US
dc.contributor.publisherUniversity of Maryland (College Park, Md.)en_US
dc.contributor.departmentMechanical Engineeringen_US
dc.subject.pqcontrolledMechanical engineeringen_US
dc.subject.pqcontrolledMechanicsen_US
dc.subject.pqcontrolledMaterials Scienceen_US
dc.subject.pquncontrolledAdditive manufacturingen_US
dc.subject.pquncontrolledHigh strain rateen_US
dc.subject.pquncontrolledInconelen_US
dc.subject.pquncontrolledKolsky baren_US
dc.subject.pquncontrolledSplit Hopkinson baren_US


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record