Show simple item record

dc.contributor.advisorWellstood, Frederick C.en_US
dc.contributor.advisorLobb, Christopher J.en_US
dc.contributor.authorBallard, Cody Jamesen_US
dc.date.accessioned2019-01-31T06:32:28Z
dc.date.available2019-01-31T06:32:28Z
dc.date.issued2018en_US
dc.identifierhttps://doi.org/10.13016/zsk8-ol6u
dc.identifier.urihttp://hdl.handle.net/1903/21584
dc.description.abstractThis dissertation examines the design, fabrication, and characterization of a superconducting lumped-element tunable LC resonator that is used to vary the coupling between two superconducting qubits. Some level of qubit-qubit coupling is needed to perform gating operations. However, with fixed coupling, single qubit operations become considerably more difficult due to dispersive shifts in their energy levels transitions that depend on the state of the other qubit. Ideally, one wants a system in which the qubit-qubit coupling can be turned off to allow for single qubit operations, and then turned back on to allow for multi-qubit gate operations. I present results on a device that has two fixed-frequency transmon qubits capacitively coupled to a tunable thin-film LC resonator. The resonator can be tuned in situ over a range of 4.14 GHz to 4.94 GHz by applying an external magnetic flux to two single-Josephson junction loops, which are incorporated into the resonator’s inductance. The qubits have 0-to-1 transition frequencies of 5.10 GHz and 4.74 GHz. To isolate the system and provide a means for reading out the state of the qubit readout, the device was mounted in a 3D Al microwave cavity with a TE101 mode resonance frequency of about 6.1 GHz. The flux-dependent transition frequencies of the system were measured and fit to results from a coupled Hamiltonian model. With the LC resonator tuned to its minimum resonance frequency, I observed a qubit-qubit dispersive shift of 2χ_qq≈ 0.1 MHz, which was less than the linewidth of the qubit transitions. This dispersive shift was sufficiently small to consider the coupling “off”, allowing single qubit operations. The qubit-qubit dispersive shift varied with the applied flux up to a maximum dispersive shift of 2χ_qq≈ 6 MHz. As a proof-of-principle, I present preliminary results on performing a CNOT gate operation on the qubits when the coupling was “on” with 2χ_qq≈ 4 MHz. This dissertation also includes observations of the temperature dependence of the relaxation time T1 of three Al/AlOx/Al transmons. We found that, in some cases, T1 increased by almost a factor of two as the temperature increased from 30 mK to 100 mK. We found that this anomalous behavior was consistent with loss due to non-equilibrium quasiparticles in a transmon where one electrode in the tunnel junction had a smaller volume and slightly smaller superconducting energy gap than the other electrode. At sufficiently low temperatures, non-equilibrium quasiparticles accumulate in the electrode with a smaller gap, leading to an increased density of quasiparticles at the junction and a corresponding decrease in the relaxation time. I present a model of this effect, use the model to extract the density of non-equilibrium quasiparticles in the device, and find the values of the two superconducting energy gaps.en_US
dc.language.isoenen_US
dc.titleVariable Qubit-Qubit Coupling Via a Tunable LC Resonatoren_US
dc.typeDissertationen_US
dc.contributor.publisherDigital Repository at the University of Marylanden_US
dc.contributor.publisherUniversity of Maryland (College Park, Md.)en_US
dc.contributor.departmentPhysicsen_US
dc.subject.pqcontrolledCondensed matter physicsen_US
dc.subject.pqcontrolledQuantum physicsen_US
dc.subject.pquncontrolledcavityen_US
dc.subject.pquncontrolledcouplingen_US
dc.subject.pquncontrolledquasiparticlesen_US
dc.subject.pquncontrolledresonatoren_US
dc.subject.pquncontrolledsuperconductingen_US
dc.subject.pquncontrolledtransmonen_US


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record