Mechanical Engineering

Permanent URI for this communityhttp://hdl.handle.net/1903/2263

Browse

Filters

2022 - 20232

Settings

Subject: search.filters.subject.vacuum

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    PERFORMANCE ENHANCEMENTS OF MICRO CORIOLIS VIBRATORY GYROSCOPES THROUGH LINEARIZED TRANSDUCTION AND TUNING MECHANISMS
    (2023) Knight, Ryan; DeVoe, Don L; Mechanical Engineering; Digital Repository at the University of Maryland; University of Maryland (College Park, Md.)
    A quadruple mass Microelectromechanical System (MEMS) Coriolis vibratory gyroscope has been re-engineered with the singular focus of minimizing nonlinear transduction mechanisms, thereby allowing for angle random walk (ARW) noise reduction when operating at amplitudes higher than 2 μm. The redesign involved six primary steps: (i) the creation of an aspect-ratio independent deep reactive ion etch with minimal notching on 100 μm thick silicon-on-insulator device layer, (ii) the creation of micro-torr vacuum packaging capability, enabling operation at the thermoelastic dissipation limit of silicon, (iii) the redesign of Coriolis mass folded flexures and shuttle springs, (iv) the linearization of the antiphase coupler spring rate while maintaining parasitic modal separation, (v) the substitution of parallel plate transducers with linear combs, and (vi) the implementation of dedicated force-balanced electrostatic frequency tuners. Cross-axis stiffness is also reduced through folded-flexure moment balancing to further reduce ARW. By balancing positive and negative Duffing frequency contributions, net fractional frequency nonlinearity was reduced to -20 ppm. The gyroscope presented in this research has achieved, a first reported of its kind, an ARW of 0.0005 °/√hr, with an uncompensated bias instability of 0.08 °/hr. These advancements hold promise for enhancing navigation and North-finding applications. In tandem with gyroscope performance enhancements, vacuum packaging of ceramic chip carrier physics packages has achieved pressure levels below 1 micro-torr, a first in the field and remains state-of-the-art. Besides high-performance MEMS inertial sensors, ultrahigh vacuum packaging proves beneficial for chip scale atomic clocks, which require micro-torr vacuum levels to maintain fractional frequencies less than 10^-12. Finally, an approach to tuning the quality factor mismatch between degenerate modes in as-fabricated gyroscopes has demonstrated a reduction in gyroscope bias instability. This tuning can be achieved by incorporating lead zirconate titanate into regions where the trade-off between mechanical Q, tuning Q, and bias instability reduction is balanced. Both modeling and empirical frequency data justify this approach, suggesting, for typical MEMS foundry Q mismatch of 7%, a 70× reduction in bias instability.
  • Thumbnail Image
    Item
    Wave-Powered and Zero-Discharging Membrane-Distillation Desalination System: Conceptual Design and Analysis
    (MDPI, 2022-06-13) Kim, Gyeong Sung; Hwang, Yunho
    There are many islands without full access to electricity around the world. These energy-poor regions generally have drinking water supply issues too. Renewable energy-powered desalination units can convert seawater to freshwater by using such as oceanic wave energy to mitigate the water limitation in small islands. A novel wave-powered floating desalination system (WavoWater) was proposed for easy on-site deployment and minimal environmental impact. WavoWater can produce freshwater using a vacuum-applied air-gap membrane distillation (AGMD) system, and the heat needed for the AGMD is provided through a heat pump powered by wave energy. Small-scale experiments were conducted to estimate the water generation rate of the vacuum-applied AGMD, and the WavoWater system modeling was developed based on the experimental results and wave data observed near the City of Newport, OR, USA. Fast Fourier transform was applied to estimate the wave energy spectrum in a random sea wave state. It was evaluated that 1 m-diameter WavoWater can produce 12.6 kg of fresh water per day with about 3.1 kWh of wave energy. With the performance evaluation, the aspects of zero discharging and minimal environmental impact were also highlighted for the stand-alone wave-powered desalination system.